June 01, 2006
Finishing the fuel circuit
At least, that was my intention. It so hard to find a store were they sell proper material that I will NOT finish this today. I'm also thinking of where to put the post-fuelpump filter, behind the rear bulkhead, near the pump, or at the front in the engine bay.
To solve yesterdays' problem I cut off a piece from the fuel return pipe. Now I have another problem that the hose doesn't fit.
Fuel tank connected to the pre-pump fuel filter. In the background my shoes.
The bracket for the MAP sensor, will be fitted against the left footwell panel.
Posted by Marnix Renne at 08:14 PM
June 02, 2006
Cooling hoses
Fitted the fuel regulator
Connected this hose from the left hand side of the oil cooler...
...to the the upper right connector of the engine (below the fuel rail)
Since I do not use a heater, I directly connected the output of the ...
...to the right hand side of the oil cooler
Posted by Marnix Renne at 04:40 PM
Cooling hoses (continued)
In between the inlet manifold you can see the hose where the breather filter must be connected.
Posted by Marnix Renne at 04:54 PM